| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
media: intel/ipu6: do not handle interrupts when device is disabled
Some IPU6 devices have shared interrupts. We need to handle properly
case when interrupt is triggered from other device on shared irq line
and IPU6 itself disabled. In such case we get 0xffffffff from
ISR_STATUS register and handle all irq's cases, for what we are not
not prepared and usually hang the whole system.
To avoid the issue use pm_runtime_get_if_active() to check if
the device is enabled and prevent suspending it when we handle irq
until the end of irq. Additionally use synchronize_irq() in suspend |
| In the Linux kernel, the following vulnerability has been resolved:
net/smc: initialize close_work early to avoid warning
We encountered a warning that close_work was canceled before
initialization.
WARNING: CPU: 7 PID: 111103 at kernel/workqueue.c:3047 __flush_work+0x19e/0x1b0
Workqueue: events smc_lgr_terminate_work [smc]
RIP: 0010:__flush_work+0x19e/0x1b0
Call Trace:
? __wake_up_common+0x7a/0x190
? work_busy+0x80/0x80
__cancel_work_timer+0xe3/0x160
smc_close_cancel_work+0x1a/0x70 [smc]
smc_close_active_abort+0x207/0x360 [smc]
__smc_lgr_terminate.part.38+0xc8/0x180 [smc]
process_one_work+0x19e/0x340
worker_thread+0x30/0x370
? process_one_work+0x340/0x340
kthread+0x117/0x130
? __kthread_cancel_work+0x50/0x50
ret_from_fork+0x22/0x30
This is because when smc_close_cancel_work is triggered, e.g. the RDMA
driver is rmmod and the LGR is terminated, the conn->close_work is
flushed before initialization, resulting in WARN_ON(!work->func).
__smc_lgr_terminate | smc_connect_{rdma|ism}
-------------------------------------------------------------
| smc_conn_create
| \- smc_lgr_register_conn
for conn in lgr->conns_all |
\- smc_conn_kill |
\- smc_close_active_abort |
\- smc_close_cancel_work |
\- cancel_work_sync |
\- __flush_work |
(close_work) |
| smc_close_init
| \- INIT_WORK(&close_work)
So fix this by initializing close_work before establishing the
connection. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw89: fw: scan offload prohibit all 6 GHz channel if no 6 GHz sband
We have some policy via BIOS to block uses of 6 GHz. In this case, 6 GHz
sband will be NULL even if it is WiFi 7 chip. So, add NULL handling here
to avoid crash. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: mv88e6xxx: don't use devres for mdiobus
As explained in commits:
74b6d7d13307 ("net: dsa: realtek: register the MDIO bus under devres")
5135e96a3dd2 ("net: dsa: don't allocate the slave_mii_bus using devres")
mdiobus_free() will panic when called from devm_mdiobus_free() <-
devres_release_all() <- __device_release_driver(), and that mdiobus was
not previously unregistered.
The mv88e6xxx is an MDIO device, so the initial set of constraints that
I thought would cause this (I2C or SPI buses which call ->remove on
->shutdown) do not apply. But there is one more which applies here.
If the DSA master itself is on a bus that calls ->remove from ->shutdown
(like dpaa2-eth, which is on the fsl-mc bus), there is a device link
between the switch and the DSA master, and device_links_unbind_consumers()
will unbind the Marvell switch driver on shutdown.
systemd-shutdown[1]: Powering off.
mv88e6085 0x0000000008b96000:00 sw_gl0: Link is Down
fsl-mc dpbp.9: Removing from iommu group 7
fsl-mc dpbp.8: Removing from iommu group 7
------------[ cut here ]------------
kernel BUG at drivers/net/phy/mdio_bus.c:677!
Internal error: Oops - BUG: 0 [#1] PREEMPT SMP
Modules linked in:
CPU: 0 PID: 1 Comm: systemd-shutdow Not tainted 5.16.5-00040-gdc05f73788e5 #15
pc : mdiobus_free+0x44/0x50
lr : devm_mdiobus_free+0x10/0x20
Call trace:
mdiobus_free+0x44/0x50
devm_mdiobus_free+0x10/0x20
devres_release_all+0xa0/0x100
__device_release_driver+0x190/0x220
device_release_driver_internal+0xac/0xb0
device_links_unbind_consumers+0xd4/0x100
__device_release_driver+0x4c/0x220
device_release_driver_internal+0xac/0xb0
device_links_unbind_consumers+0xd4/0x100
__device_release_driver+0x94/0x220
device_release_driver+0x28/0x40
bus_remove_device+0x118/0x124
device_del+0x174/0x420
fsl_mc_device_remove+0x24/0x40
__fsl_mc_device_remove+0xc/0x20
device_for_each_child+0x58/0xa0
dprc_remove+0x90/0xb0
fsl_mc_driver_remove+0x20/0x5c
__device_release_driver+0x21c/0x220
device_release_driver+0x28/0x40
bus_remove_device+0x118/0x124
device_del+0x174/0x420
fsl_mc_bus_remove+0x80/0x100
fsl_mc_bus_shutdown+0xc/0x1c
platform_shutdown+0x20/0x30
device_shutdown+0x154/0x330
kernel_power_off+0x34/0x6c
__do_sys_reboot+0x15c/0x250
__arm64_sys_reboot+0x20/0x30
invoke_syscall.constprop.0+0x4c/0xe0
do_el0_svc+0x4c/0x150
el0_svc+0x24/0xb0
el0t_64_sync_handler+0xa8/0xb0
el0t_64_sync+0x178/0x17c
So the same treatment must be applied to all DSA switch drivers, which
is: either use devres for both the mdiobus allocation and registration,
or don't use devres at all.
The Marvell driver already has a good structure for mdiobus removal, so
just plug in mdiobus_free and get rid of devres. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: ar9331: register the mdiobus under devres
As explained in commits:
74b6d7d13307 ("net: dsa: realtek: register the MDIO bus under devres")
5135e96a3dd2 ("net: dsa: don't allocate the slave_mii_bus using devres")
mdiobus_free() will panic when called from devm_mdiobus_free() <-
devres_release_all() <- __device_release_driver(), and that mdiobus was
not previously unregistered.
The ar9331 is an MDIO device, so the initial set of constraints that I
thought would cause this (I2C or SPI buses which call ->remove on
->shutdown) do not apply. But there is one more which applies here.
If the DSA master itself is on a bus that calls ->remove from ->shutdown
(like dpaa2-eth, which is on the fsl-mc bus), there is a device link
between the switch and the DSA master, and device_links_unbind_consumers()
will unbind the ar9331 switch driver on shutdown.
So the same treatment must be applied to all DSA switch drivers, which
is: either use devres for both the mdiobus allocation and registration,
or don't use devres at all.
The ar9331 driver doesn't have a complex code structure for mdiobus
removal, so just replace of_mdiobus_register with the devres variant in
order to be all-devres and ensure that we don't free a still-registered
bus. |
| In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: lock against ->sock changing during sysfs read
->sock can be set to NULL asynchronously unless ->recv_mutex is held.
So it is important to hold that mutex. Otherwise a sysfs read can
trigger an oops.
Commit 17f09d3f619a ("SUNRPC: Check if the xprt is connected before
handling sysfs reads") appears to attempt to fix this problem, but it
only narrows the race window. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: bcm_sf2: don't use devres for mdiobus
As explained in commits:
74b6d7d13307 ("net: dsa: realtek: register the MDIO bus under devres")
5135e96a3dd2 ("net: dsa: don't allocate the slave_mii_bus using devres")
mdiobus_free() will panic when called from devm_mdiobus_free() <-
devres_release_all() <- __device_release_driver(), and that mdiobus was
not previously unregistered.
The Starfighter 2 is a platform device, so the initial set of
constraints that I thought would cause this (I2C or SPI buses which call
->remove on ->shutdown) do not apply. But there is one more which
applies here.
If the DSA master itself is on a bus that calls ->remove from ->shutdown
(like dpaa2-eth, which is on the fsl-mc bus), there is a device link
between the switch and the DSA master, and device_links_unbind_consumers()
will unbind the bcm_sf2 switch driver on shutdown.
So the same treatment must be applied to all DSA switch drivers, which
is: either use devres for both the mdiobus allocation and registration,
or don't use devres at all.
The bcm_sf2 driver has the code structure in place for orderly mdiobus
removal, so just replace devm_mdiobus_alloc() with the non-devres
variant, and add manual free where necessary, to ensure that we don't
let devres free a still-registered bus. |
| NVIDIA CUDA Toolkit for all platforms contains a vulnerability in the nvdisasm binary where a user may cause an out-of-bounds read by passing a malformed ELF file to nvdisasm. A successful exploit of this vulnerability may lead to a partial denial of service. |
| NVIDIA CUDA Toolkit for all platforms contains a vulnerability in nvJPEG where a local authenticated user may cause a divide by zero error by submitting a specially crafted JPEG file. A successful exploit of this vulnerability may lead to denial of service. |
| NVIDIA CUDA Toolkit for all platforms contains a vulnerability in nvJPEG where a local authenticated user may cause a GPU out-of-bounds write by providing certain image dimensions. A successful exploit of this vulnerability may lead to denial of service and information disclosure. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| NVIDIA CUDA Toolkit contains a vulnerability in cuobjdump, where an unprivileged user can cause a NULL pointer dereference. A successful exploit of this vulnerability may lead to a limited denial of service. |
| NVIDIA Container Toolkit contains an improper isolation vulnerability where a specially crafted container image could lead to untrusted code running in the host’s network namespace. This vulnerability is present only when the NVIDIA Container Toolkit is configured in a nondefault way. A successful exploit of this vulnerability may lead to denial of service and escalation of privileges. |
| NVIDIA Container Toolkit contains an improper isolation vulnerability where a specially crafted container image could lead to untrusted code obtaining read and write access to host devices. This vulnerability is present only when the NVIDIA Container Toolkit is configured in a nondefault way. A successful exploit of this vulnerability may lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| NVIDIA Container Toolkit contains an improper isolation vulnerability where a specially crafted container image could lead to modification of a host binary. A successful exploit of this vulnerability may lead to code execution, denial of service, escalation of privileges, information disclosure, and data tampering. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Validate passed in drm syncobj handles in the performance extension
If userspace provides an unknown or invalid handle anywhere in the handle
array the rest of the driver will not handle that well.
Fix it by checking handle was looked up successfully or otherwise fail the
extension by jumping into the existing unwind.
(cherry picked from commit a546b7e4d73c23838d7e4d2c92882b3ca902d213) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Validate passed in drm syncobj handles in the timestamp extension
If userspace provides an unknown or invalid handle anywhere in the handle
array the rest of the driver will not handle that well.
Fix it by checking handle was looked up successfully or otherwise fail the
extension by jumping into the existing unwind.
(cherry picked from commit 8d1276d1b8f738c3afe1457d4dff5cc66fc848a3) |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HCI: Remove HCI_AMP support
Since BT_HS has been remove HCI_AMP controllers no longer has any use so
remove it along with the capability of creating AMP controllers.
Since we no longer need to differentiate between AMP and Primary
controllers, as only HCI_PRIMARY is left, this also remove
hdev->dev_type altogether. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Use 64 bit variable to avoid 32 bit overflow
For example, in the expression:
vbo = 2 * vbo + skip |
